The daily use process of a fully automatic binding machine

Automatic binding machine is generally automatic punching automatic press riveting two button to complete the binding work, drilling machine is based on the data of the thickness of the corresponding length automatic riveting tube cut down, gold figure automatic bookbinding machine is a key operation certificate, have advanced tube feeding system, Queliao alarm support uses the OMRON brand reliable quality, advanced system, tube feeding; can handle good bending or irregular hose pipe; this function can guarantee the use of the last tube, to avoid wasting a lot of hose supplies.

When the machine is working, if there are any faults or alarm prompts, the alarm location LED on the binding machine's panel will always shine or blink continuously. It can be detected and processed according to the following methods.

When the punching is finished, the bookbinding machine does not stock, and no riveting tube is stapled. It usually detects the causes of the problems from three aspects. First, let's see if the cutting motor has rotation. Secondly, let's see if the gap between the blanking pipe and the gear is too large. Let's see whether the angle of the switch is correct.

The machine is working normally, the sudden feeding alarm, flashing lights, first check whether the riveting tube will be exhausted or lack of material, this time will pass according to the needle on the top of the bookbinding machine is inserted from the feeding port, until the plastic pipe is inserted, attention should not be too hard, clockwise rotation of 360 degrees down so, the remaining tube set in the needle, and with the needle together from the inlet out through the needle top with the remaining material, insert a new riveting tube will continue after binding. It is important to note that the bending of the nylon tube not, or can not properly use.

Sometimes the needle is taken out, but no material is taken out. After inserting the new pipe, the machine still can not work. Then there is a leftover on the thimble, according to the pin action key, and the remaining material on the thimble is not fixed with tweezers forceps, so when the thimble drops automatically, the remaining material is removed. Note: the thimble is not completely down, not out before the riveting tube and a thimble, do not use tweezers pull about pumping pipe, so as not to distort the thimble, damage to the machine does not work.

There is no problem encountered in the machine, is not to look at the material, the riveting tube material, now a small factory in order to seize more supplies market share blindly down prices, the material used is especially hard, mostly plastic material, although at that time can be used, can make the machine frequently eat these hard things, sooner or later for indigestion, and damage in the machine pipe cutter, it is recommended that you use the original nylon material supplies to manufacturers or similar consumables.