On the use of a manual binding machine

Many users will encounter problems when using a manual bookbinding machine.

1, install the handle: put the handle with the box into the right side of the binding machine (notice: the working angle of the handle), and tighten it with the locking screw.

2, the amount of paper: it must be determined according to the quantity of paper, which can not be overdose. Otherwise, it may lead to the following bad conditions:

(1) the handle of the handle can not be pressed down, and the paper barrier can not be penetrated.

The margin is not balanced, and the paper side roll angle is easy to occur.

It causes the distortion of the square shaft, which leads to the shortening of the service life of the binding machine.

3, the adjustment of the margin of paper is the principle that the size of the margin is determined according to the diameter of the ring. The method is to adjust the scale by adjusting the screw (behind the binding machine) to reach the margin. The rules are: the diameter of the ring is large, the margin of the paper is large, the diameter of the drawing circle is small, and the margin of the paper is small.

4, drilling operation method:

(1) the paper is tidy and tidy, close to the location block, the paper is sent into the machine parallel to the machine, and the top is in place.

Hold the paper with the left hand, hold the handle in the right hand, press down to the blade and penetrate the paper, and then lift the handle.

A smooth hand will be taken out of the paper, such as the appearance of a paper phenomenon, repeat the handle press down, and then up to the position of the paper can be taken out.

5. The method of upper needle:

Fixed screw loose pin on the device, remove the pins, set the hook needle tail hanging into the staple fixing hole, perpendicular to pin is sheathed in the fixing screw rod for in situ, pins on the top tight.

6. Methods of binding:

When binding, the presser foot hand wheel clockwise rising pressure foot, the binding material into the presser foot, let go of the selected location of presser foot handwheel automatically pressed, then the presser foot to hand rotation to the counter clockwise 180 degrees is locked, then set the needle handle to rotate counterclockwise, set the needle through material. When the transmission is in place, the lead arm will automatically put in order the needle hook line slot, at this time to handle, in order to exit the needle at the same time, the binding will follow through binding material, to loosen the clockwise pressure foot wheel to complete a binding, repeat the above procedure, legislation can complete binding task.